corn row led bulbs manufacturer Energy-saving, high brightness, long life, low failure rate, has become a common home users like a light bulb. But low failure rate is not equal to no failure, when the LED lamp head failure and what should we do - change the light? What a luxury! In fact, the cost of maintaining the corn row led bulbs manufacturer is very low and the technical difficulty is not high, so ordinary people can operate.

Bead damage

When the corn row led bulbs manufacturer turns on the lamp, some of the lamp beads are not bright, so you can basically judge that the lamp beads are damaged. The damaged bead is usually visible to the naked eye -- there is a dark spot on the surface of the bead, indicating that it has been burned. Sometimes the lamp beads are connected in series and then in parallel, so a lamp bead loss, will cause a lamp bead is not bright. We offer two repair programs according to the amount of lamp bead damage.

1. Small amount of damage

If only one or two lamp beads are broken, we can repair them in these two ways:

1. Find the broken lamp bead and short circuit it with a wire connecting the metal at both ends. The effect of this is that most of the beads can light up normally, only broken individual beads do not light up, and the overall brightness is not affected.

2. If you have strong hands-on ability, you can go to the Internet to buy the same model of lamp beads (10 yuan a big bag) and replace them by yourself -- use electric iron (blow dryer for a while) to heat the old lamp beads until the glue on the back of the old lamp beads melts, and use tweezers to remove the old lamp beads (do not use your hands, too hot). At the same time, install the new lamp beads while they are hot (pay attention to the positive and negative poles), and you are done!

Two, a large number of damage

If a large number of beads are damaged, it is recommended to replace the whole bead board. Lamp bead board is also available on the Internet. Pay attention to three points when buying:

1. Measure the size of your lamp;

2. Look at the appearance of lamp bead board and starter connector (explain later);

3. Remember the output power range of the initiator (explained later).

The three points of the new lamp bead board, must be the same as the old lamp bead board - the replacement of the lamp bead board is very simple, the old lamp bead board is fixed on the lamp holder with screws, can be taken off directly. The new lamp bead board is fixed with a magnet. When replacing the new lamp bead board, take it off and connect the connector of the starter.

corn row led bulbs manufacturer https://www.zliec.com/75W-Led-Corn-Row-Led-Lights.html