The characteristics of cnc wire cutting machine is not suitable for working in dirty and high temperature and humidity environment, the power supply environment also has higher requirements, the power supply voltage of the machine tool should not be inferior to ±10%, and the corresponding balance and stability. A voltage regulator must be installed in an excessively bad power grid. characteristics of cnc wire cutting machine In addition to the normal maintenance of cleanliness and lubrication, you must also carefully maintain the following parts:

1, guide rail and screw, must not be contaminated with dirty water and dirt, once contaminated with dirt, to wipe clean with clean cotton yarn and then with absorbent cotton soaked 10# oil gently rub coated again.

2, characteristics of cnc wire cutting machine guide wheel and bearing, for the life of the guide wheel and bearing, should also be too dirty coolant replaced, such as short time do not open the machine tool, to no water to let the guide wheel turn for dozens of seconds, throw out the paint, remove the guide wheel seat plug, inject grease, The dirt is discharged through the oil gap so that the guide wheel and bearing are often in a cleaner state.

3, the online cable between the control cabinet and the machine tool, the mop part should have a cover plate or plastic plate protection, can not be trampled at will, the cable should be in a relaxed free state, can not be pulled by external force, can not make the cable plug force, Do not frac the cable corrugated jacket flat.

4, characteristics of cnc wire cutting machine The console (cabinet) should be handled gently when moving, and the greasy hand should not plug and remove the touch connector or keyboard.

5, any part of the bed shall not be knocked or collided, especially because of the over-stroke movement of the wire frame and bed interference, which will seriously damage the machine parts or accuracy.

6, we should often pay attention to make the conductive block in a good conductive and insulated state between the bed, the workbench pad must be insulated with the bed, the stepper motor drag line should be in a free state, the stepper motor to ensure that there is no dirty water immersion

characteristics of cnc wire cutting machine https://www.talentcnc.com/Characteristics-of-DK77120-CNC-wire-cutting-machine.html